XGuard RC XGlow Pro Throttle Signal Pickup Cable Set

XGuard RC XGlow Pro Throttle Signal Pickup Cable Set
In Stock Online
Usually ships in 24 hours
Check Store Availability
Please be aware that pricing and product availability in-store may vary from what’s available online because each store is independently owned and operated.
The optional XGuard RC XGlow Pro Throttle Signal Pickup Cable allows users to add "Anti-Hot Start" to their XGuard equipped nitro helicopter. Installation is simple by inserting the silver pin into the XGlow servo connector, and the opposite side (side with 1 single yellow wire) is connected to a Y-Harness that is plugged into the throttle port of your receiver or gyro system.

Once connected, it allows the XGlow to know the throttle servo position to prevent hot starts, and runout prevention when additionally connected to the RPM port of the governor sensor*.

*Note: Runout prevention is only possible with both AAVXG0203, and AAVXG0202 installed to the XGuard.

This product was added to our catalog on December 24, 2020