Tekno RC Aluminum Single Sided Clamping Servo Horn (25T)

Tekno RC Aluminum Single Sided Clamping Servo Horn (25T)
In Stock Online
Usually ships in 24 hours
$1.99 flat rate shipping! Learn More
Read Reviews
Write a Review
Check Store Availability
Please be aware that pricing and product availability in-store may vary from what’s available online because each store is independently owned and operated.

This is the Tekno RC Aluminum Single Sided Clamping Servo Horn for 25 tooth servo splines; such as Futaba, Savox and ProTek R/C.

This Tekno RC Aluminum Servo Horn is designed to minimize forces transmitted back to the servo spline. The horn utilizes a bottom mount design that, as opposed to a top mount, lowers the leverage point. This means your servo will be protected better to keep you in the race.

There are two mounting positions to fine tune your application. A hefty M3 locking screw ensures the servo horn will never come loose again. The M3 screw is also easy to tighten down compared to the smaller M2 screws that easily strip out on other servo horns. Use TKR1325 (M3x14mm flathead screw) for mounting the steering linkage to your Tekno RC vehicle.  Use thread locking compound on all metal-to-metal connections.

Although this horn was designed specifically for the Tekno RC line of vehicles, it can also be used in most other applications.

Note: Tekno R/C strongly recommends using the inside (short) mounting hole for use in Tekno RC vehicles. This will make the steering response smoother and also protect your servo better.

This product was added to our catalog on January 6, 2016

Verified Owner
Monday, Oct 1 2018 (about 3 years ago)
Tekno RC Aluminum Single Sided Clamping Servo Horn (25T)
Goes perfectly with my et48.3 and the Protek 170TBL servo. So much better than the stock plastic servo horn. This really should be included in the kit. Every Tekno kit I get from here on out will have one of these on the order...
Verified Owner
Wednesday, Jan 18 2017 (about 4 years ago)
Tekno RC Aluminum Single Sided Clamping Servo Horn (25T)
This is a must if you own a TEKNO vehicle!

I have ProTek Brushless Black Label servo hooked up with EB48.3 and it is a killer with this aluminum servo horn.
I have no worries of stripping the servo horn and it has stayed on the servo with no problems.
Make sure to watch which direction the screw goes it because if you install it in wrong direction, it does not stay on well.