Servo Lead & Terminal Crimping Tool by ProTek RC
The ProTek RC Servo Lead & Terminal Crimping Tool is the tool you need to make custom length signal wires for your ESCs, receiver batteries and servos. This tool safely secures the connector pins on wire sizes between 14 and 28awg, without damaging the pin or the wire. Simply strip a short length of the shielding off the wires, install the connector pin into the tool, insert the wire into the pin, and squeeze the tool to crimp the pin in place.
Want more? Unlike most terminal crimping tools, the ProTek tool will allow you to strip 12, 16 and 22awg wire, and includes a cutter as well. Crimps 20, 24 and 28 AWG wire.
NOTE: When changing the length of your signal wires or receiver battery connectors, for the best results we recommend you use new connectors.
- PTK-5008 - Futaba Style
- PTK-5009 - JR Style Servo Connectors
- PTK-5010 - JST Male Style Connectors
- PTK-5011 - JST Female Style Connectors
This product was added to our catalog on August 26, 2016.
Not the best but ok for the cost with a little work can make it a so so crimper that will do a good crimp. The down fall Is it hard to hold untill you learn what to do and mite need grinding to make it crimp as tight as needed..)
Did you guys even test this thing before you packaged it up and sold it.
This tool is in no ways reflection of all your other RC products which are high quality.)