ProTek RC High Voltage Surface/Air Receiver Battery
The ProTek R/C 2200mAh HV LiPo Receiver Battery Pack brings LiHV power to your servos! This battery is a direct fit in Mugen and Team Associated 1/8 scale battery boxes, and will provide improved power and response from your HV servos.
These packs are built with a Lexan plastic shell around the outside of the battery, and then covered in blue heat shrink. The Lexan shell is designed to protect the battery cells while in the vehicle, for longer life. Note that due to the Lexan shell, sometimes the battery may feel soft to the touch on the outside of the battery; this is normal as there is a small air gap between the Lexan shell and the battery cells inside.
Features:
- Direct fit for 1/8 Losi 8IGHT and 1/8 HB battery boxes
- Works great Helicopters and Airplanes as well!
- Built in Lexan shell for added protection
- Great for HV servos!
IMPORTANT LITHIUM POLYMER SAFETY INFORMATION
- DO NOT leave a battery in your model when charging
- DO NOT leave lithium batteries unattended when charging
- ALWAYS balance charge lithium battery
- ALWAYS use a LiPo Safe charging bag/box
- YOU MUST use a Li-Poly specific charger to charge lithium batteries (NiMH or NiCD only chargers WILL NOT WORK!)
- YOU MUST not over discharge lithium battery packs
- READ & UNDERSTAND the instructions carefully before operating this battery
NOTE: When using high energy Li-Polymer Batteries, please do not over-discharge or over-charge batteries as this will result in overheated batteries. Discharging capacity can't exceed 80% of the max capacity of the pack after full charging to ensure a good cycle performance. It is recommended to fully charge a brand new battery before using and only discharge the battery 50% for the first 5 cycles. Always monitor race time and/or set a low voltage warning on ESC (End voltage cannot be lower than 3.2v per cell). Do not use a battery that has too low a voltage. Do not expose batteries to sunshine or store/charge batteries at temperatures above 35°C or in a closed car. The high-temperature environment could cause damage to the pack or make it burst. If the battery becomes hot while fast charging, high current discharging, or racing, do not charge it until it has cooled completely. Wait about 20 mins, then inspect prior to recharging.
Includes:
- (1) ProTek LiHV 7.6V 2200mAh
Specifications
Nominal Voltage: | 7.6V (2S) |
---|---|
Capacity: | 2200mAh |
Maximum Charge Rate: | 1C (2.2A) |
Discharge Rates | |
Continuous: | 8C |
Peak: | (Not Available) |
Cell Configuration: | 2S2P |
Watt Hours: | 16.72Wh |
ROAR Approved: | No |
Connectors | |
Battery: | JR |
Balance: | XH |
Dimensions (LxWxH): | 3.35x1.18x0.67in (85x30x17mm) |
Weight: | 3.00oz (85g) |
Battery Manual
Warranty Information
This product was added to our catalog on December 19, 2018
- Losi 8IGHT-X
- Mugen MBX6 Original
- Mugen MBX6R
- Mugen MBX6T
- Mugen MBX7 Original
- Mugen MBX7R
- Mugen MBX8 Original
- Mugen MBX8R
- Mugen MBX8T Original
- Mugen MGT7 Original
- S-Workz S350 BK1
- S-Workz S350 BK1 EVO
- S-Workz S350 BX1
- S-Workz S350 EVO II
- Serpent SRX8 Cobra
- Team Associated RC8B3
- Team Associated RC8B3.1
- Team Associated RC8B3.2
- Team Associated RC8B4
- Team Associated RC8T3
- Team Associated RC8T3.1
- Team Associated RC8T3.2
- Team Associated RC8T4