Multi Rotor 25 Expansion Pack 25-Amp ESC (No BEC) by Castle Creations

Castle Creations
CSE010-0135-00
$1.99 Flat Rate Shipping!
Low Price: $34.99
This item is eligible for $1.99 flat rate shipping Learn More

This is the Castle Creations Multi Rotor 25 Expansion Pack 25-Amp ESC with no BEC. Got more than four rotors? Pick up a few single Multi-Rotor ESC's and finish your project without buying any gear you don't need! The small footprint and lightweight design makes it the perfect choice for smaller Multi-Rotors. A 490 Hz refresh rate makes the QuadPack 25 the epitome of stability during all aspects of flight from a simple hover to the most extreme maneuvers. Recommended for platforms pulling up to 25 amps** and running up to 6S LiPo, your Quadcopter or Multi-Rotor platform will perform as never before. While pre-programmed for your Multi-Rotor, the QuadPack 25 offers industry-leading software functions and USB programming capability via Castle Link USB adapter should you require them (Castle Link sold separately).

Specifications:
Continuous Maximum Current
: 25A
Input Voltage
: 7.4-22.2V (2-6S LiPo)
Input Connector Types
: Bare Wire
Output Connector Types
: Bare Wire
Length
: 1.72in (43.7mm)
Width
: 0.72 in (18.2mm)
Height
: 0.32 in (8.1mm)
Weight
: 0.63 oz (17.8 g) each without wires
BEC Voltage
: N/A

**NOTE: RC HOBBY APPLICATION RATING: 25 amps for the duration of a single 4,000 mAh battery pack with the ESC's in contact with a 5 mph airflow of 25C (77F) or cooler air. Controller temperature must never exceed 100C (212F). Exceeding current or temperature ratings may damage components and may shorten the life of the ESC. Always verify system current draw at full-throttle. Decrease load or increase airflow to decrease the ESCís operating temperature. 

This product was added to our catalog on April 15, 2014.