Mugen Aluminum Rear Chassis Wear Guard by Xtreme Racing
Check Store Availability
Please be aware that pricing and product availability in-store may vary from what’s available online because each store is independently owned and operated.
Xtreme Racing
XTR12307

This is a optional Xtreme Racing Aluminum Rear Chassis Wear Guard, and is intended for use with the Mugen MBX6 and MBX7 1/8 buggies, as well as the MBX7T 1/8 truck. This Part is made from 1/8" thick T6 Aluminum Plate, to help prevent excessive wear to the back of the chassis.
Note: It is recommended that you use 1/8" (3mm) longer fasteners for better support. These fasteners are NOT included.
Note: It is recommended that you use 1/8" (3mm) longer fasteners for better support. These fasteners are NOT included.
This product was added to our catalog on January 9, 2009.
Dan S.
Verified Owner
Saturday, Oct 2 2010 (about 7 years ago)
Xtreme Racing Mugen Aluminum Rear Chassis Wear Guard
this last so much longer then the other skid plates and will fit's any 1/8th mugen)
Drew Sheffield
Verified Owner
Tuesday, Feb 15 2011 (about 7 years ago)
Xtreme Racing Mugen Aluminum Rear Chassis Wear Guard
Much better than plastic ones. Doesnt get hung up on jumps and it lasts much longer than a 3 pack of plastic ones. Im on my second one but it lasts almost a whole season depending on how abrasive the tracks you race at are)
maxime coraboeuf
Verified Owner
Thursday, Aug 12 2010 (about 7 years ago)
Xtreme Racing Mugen Aluminum Rear Chassis Wear Guard
it is a very good Wear Guard
Very wear resistant
But too big at the beginning)
Very wear resistant
But too big at the beginning)