Jeep Snorkel (Short) by Knight Customs
This product was added to our catalog on December 21, 2016.
The Knight Customs "Short" Jeep Snorkel incorporates the same 3 piece design that allows it to flex in a roll over, but it is 10mm shorter (approximately 50mm from base to top). The snorkel cap is attached to the tube with a length of standard 7mm diameter fuel tubing (not included), that will help to prevent damage when you roll. This model is 3D Printed in Frosted Ultra Detail Matte translucent plastic that showcases fine and intricate details. The parts come unpainted and it is recommended to paint them with Tamiya acrylic paints for the best results. For the best results, Knight Customs recommends:
- Use 2 light coats of Tamiya primer.
- Sand back primer only using 1500 dry as nylon does not sand well.
- Repeat until smooth
- Paint with Tamiya TS final color.
NOTE: The snorkel should be fitted to the body using a M2x10mm screw and it is recommended to use a washer and a small rubber gromet on the underside of the body to help the snorkel flex in a roll over (hardware not included). Pre-drill holes before mounting.