Hot-Shot 2 Glow Igniter by Hobbico
This is a Hot-Shot #2 Standard Glo-Starter with Battery Charger from Hobbico. This is used to heat glow plugs to start glow-powered engines.
Proven Twist and Lock Connector ensures a secure, solid connection that won't come off, providing safer, faster starts for your model. Pre-Installed battery with included AC battery charger with hex-shaped charge end recharges the glow starter in 10 hours. A red LED glows as unit is charging. Removable red rubber socket cap prevents shorting and any dirt or dust debris from entering into the the shaft. One Year Limited Warranty USA and Canada only.
- One Hot Shot 2 Standard Glo-Starter w/red rubber protective cap
- One Hot Shot #2 Glo-Starter Battery Charger
- One Instruction/Header Card
- 1.2V AC Charger- Input: 110-120V AC 60Hz (US Standard) Output: 1.25V DC 500mA
- Overall Length: 4" (102mm)
- Shaft Length: 2-1/4" (57mm)
- Diameter: 15/16" (33mm)
This product was added to our catalog on July 5, 2007.
If you have another charger that charges Lipo & NiCd batteries, I suggest getting a charge lead for these like these: PTK-5240 or LRP65826. This is a 1500mAh NiCd you can safely charge it at 3-4 Amps. If you were around back in the day when we used round cells (NiCd or NiMh) you will know you should always fully discharge your round cell and then charge it back up. These adapters will allow you to keep your battery in better condition and charge it much faster. (just my 2 cents.))