Hobbywing XRotor BLHeli_S 30 Amp Multi-Rotor Brushless ESC

Hobbywing XRotor BLHeli_S 30 Amp Multi-Rotor Brushless ESC
Out Of Stock Online
You may back order this item and it will ship when it arrives.
$1.99 flat rate shipping! Learn More
Price: $12.49

Please Log in to receive a notification when this item arrives in stock.

Check Store Availability
Please be aware that pricing and product availability in-store may vary from what’s available online because each store is independently owned and operated.

This is the Hobbywing XRotor 30A Micro Brushless Drone ESC with BLHeli_S Firmware.


  • Super Small & Light architecture
  • F396 48MHz MCU
  • BB2 MCU (EMF8BB21F16G)
  • Premium MOSFETs (Toshiba MOSFETs for 20A & 35A ESCs, Fairchild MOSFETs for 30A ESCs)
  • Ceramic capacitors
  • 3-in-1 drive ICs, 3-ounce copper
  • Ultra high efficiency & rapid response - 4 layers of PCBs and other quality components guarantees less heat.
  • BLHeli_S Firmware Ready - The ESC supports the original BLHeli_S firmware. Users can flash or upgrade the firmware via the signal cable (on ESC) and program 4 ESCs simultaneously after connecting their flight controller to the BLHeli Suite software (if the flight controller uses the CleanFlight or beta flight firmware).
  • Damped Light Mode & OneShot125 Mode Supported
  • Damped light mode improves the motor retardation and allows users to brake the FPV drones more efficiently. Active-freewheeling technology improves driving efficiency, flight time and heat dissipation.
  • Protocol Support:
    • OneShot125 high speed throttle signal and regular throttle signal (within 500Hz) modes
    • Oneshot 42 (41.4-83.3µs)
    • Multishot(5-25µs)
    • Regular PWM (1000-2000µs)throttle signals
  • ESC + Motor combo available
FPVs with 130-280mm Diagonal 
LiPo Power input: 2S-4S    
Continuous Current: 30A
Burst Current: 40A
BEC Output: NA
Input wires: 18AWG-100mm* (Red/Black)
Output Wire: Solder tabs (no wires)
Connectors (In/Out): no
Weight / Size: 7g / 24.0x13.9x5.5mm
*Note: All the wire length above is the original length, not the length you see from the outside.