This is a Hitec D940TW Titanium Gear Servo, designed with industry leading high-resolution and state-of-the-art ultra-response technology. A 32-bit MCU and 12-bit ADC allow for unprecedented programmability and flexibility. The speedy, powerful line operates on a wide 4.8 - 8.4 voltage range, allowing use with any common battery chemistry without the need for adapters or regulators. Featuring Hitec’s industry standard 25-tooth output spline with 3mm hex screw, each D-Series servo delivers monster performance.
- Programmable PWM Digital Amplifier
- 32-Bit MCU with 12-Bit ADC Circuitry
- 4096 Resolution
- 1M Cycle Long Life Potentiometer
- Wide Operating Voltage (4.8 ~ 8.4 Volts DC)
- Dual Ball Bearing Supported Output Shaft
- 25-Tooth Output Spline
- Coreless Metal Brush Motors
- Nylon Reinforced Plastic Upper and Lower Case
- Diamond Cut Aluminum Heat Sink Center Case
- Dust Resistant and Splash Proof Case
- End Point Adjustments
- Fail Safe
- Dead Band
- Speed (Slower)
- Soft Start Rate
- Overload Protection
- Data Save / Load
- Program Reset
Specifications:Size Category: Standard
Torque: 139 oz-in @ 4.8v, 187 oz-in @ 6.0v, 229 oz-in @ 7.4v
Speed: 0.11 @ 4.8v, 0.07 @ 6.0v, 0.06 @ 7.4v
Dimensions (WxLxH): 1.57 x 0.79 x 1.50 in (39.9 x 20.1 x 38.1 mm)
Bushing Or Bearing: Bearing
Gear Type: Metal
Gear Material: Titanium
- 3 Titanium/ Steel Gears Set
- Metal/ Karbonite 1st Gear Set
- Plastic/ Aluminum Case Set
- Applicable Horns
This product was added to our catalog on October 25, 2019
I ordered this servo from Amain Hobbies in March 2020 and I did not receive it till April, 2020. Due to the pandemic I was unable to use the servo due to the country being on lockdown. I finally was able to use it weekend gone and while on the track after the 3rd lap, I realise I could not turn the steering to the right. I ran to get the truggy and noticed the gear was stripped.
How can I be compensated for this servo as this is the first time I am using the servo and I have paid $127.00 plus shipping and I must say this is unacceptable and all my end points and alignment with the steering and everything is on point.
I can be reached at 1-868-355-2339.
I look forward to hearing from you.
Scott Mc Lean