FunFly "Acro Naze32" Revision 6 Flight Controller by AbuseMarK
This product was added to our catalog on September 30, 2015.
This is the AbuseMarK FunFly "Acro Naze32" Flight Controller with Revision 6 Hardware. This "Acro" is similar to the standard Naze32, but uses the MPU6500 acc + gyro sensor. There is no pressure sensor or mag installed.
Developed by the infamous Hamasaki (AKA “timecop"), the Naze32 has become a must have piece for a variety of DIY multirotor projects. Simple to setup, with configuration based on the familiar “MultiWii” software, the Naze32 is perfect for small indoor or small to mid-sized outdoor multirotor aircraft. You can even use it as a standalone camera gimbal stabilizer! With its impressive sensors, some of the nicest GUI programs, combined with a variety of incredible features, the Naze32 will allow you to squeeze all the potential out of your aircraft. The Naze32 is nothing short of a work of art.
NOTE: Does not include Breakout Cable (ABUCABLE)
- STM32F103CBT6 32-bit ARM Cortex M3 processor (72MHz, 3.3V)
- Invensense MPU6500 MEMS accelerometer + gyro
- BMP280 Barometer
- Built-in Micro-USB for programming/firmware update
- 36x36mm size, 5 gram weight w/o headers
- Made in JAPAN
- Shipping with 16V input capable voltage regulators
Naze32 rev6 Features:
- USB on right side
- PPM/PWM input as through-hole
- 3.3V, I2C on standard-size headers
- Fully pinout compatible with rev5 accessories (OSDoge etc)
- SBUS Inverter
- Spectrum satellite
- MPU6500 MEMS gyro + accelerometer
- Sonar pads w/resistors added for direct connection to 5V sonar
- All extra pads (FT, GP, A5) on top, only sonar on bottom
- BMP280 barometer
Weight: 5 grams (7 grams with pins)
Input Voltage: 16V on input rail. 35V on voltage sense line
*NOTE: The Naze controller can be powered by up to 16V directly, however the voltage is passed through to the receiver, so the receiver must also be capable of 16V input as well.