Earthquake 3.5 1/8 RTR 4WD Nitro Monster Truck (Blue) by Redcat Racing w/2.4GHz Radio & .21 Engine
This product was added to our catalog on December 1, 2014.
This is the Redcat Racing Earthquake 3.5 1/8 Scale RTR 4WD Nitro Monster Truck, with an included 2.4GHz Radio System and .21 Nitro Engine. The 1/8 scale Earthquake 3.5 delivers BIG BLOCK power at a little block price. Part of the Redcat UltraLite Series, the Earthquake 3.5 is ready to run and ready for fun. The 3.5cc .21 big block engine provides earth shaking power and lightning fast acceleration! A specially designed composite disc brake stops this monster with authority.
The Earthquake 3.5 4x4 monster truck is the bashers dream with 2 sealed differentials, adjustable suspension, oil filled adjustable shocks, powerful engine, and 2 speed automatic transmission. Thanks to the 2 speed transmission, the Earthquake 3.5 has low end power for wheelie popping fun and second gear offers a whole new level of excitement at blistering high speeds. The automatic transmission’s shift point is adjustable so you can tune shifting characteristics to your liking.
The Earthquake 3.5 is ready to run, after following proper break in procedures, and includes a 2.4GHz radio for solid control. The aggressive monster truck tires scream “natural disaster”! These meats are made to tear up the terrain while offering great wear characteristics. There’s no need to go around when you can drive over with the Earthquake 3.5 4x4 Nitro powered Monster Truck!
- 1/8 scale nitro off-road monster truck
- Powerful 3.5cc nitro engine
- Adjustable 2-speed transmission
- 2.4GHz radio system included
- Four wheel drive excitement
Motor Type: Nitro 3.5cc. .21
Drive System: 4 Wheel Drive
Ground Clearance: 58mm
Fuel Tank Capacity: 125cc
Chassis Type: 3.0mm 6061 Aluminum
Brake Type: Composite Disc
Shocks: Oil Filled Big Bore Shocks
Radio System: 2.4GHz Radio System
Needed to complete:
- 12 AA Batteries (8 for Transmitter, 4 for Vehicle)
- Glow ignitor
- Nitro Fuel & filler bottle
UPDATE, I bought the starter kit with 2 backplates, two of the holes lined up and there is a third hole exposed on the opposite side. I made a 1/2" x 1/4" diameter standoff with one side flattened off to the thru hole, then used a washer to secure the backplate. Use blue medium loktite on the screws. It works great. Much easier to start.)