Dromida Ominus Rear Prop Guards (Black) (2) by RPM
RPM Dromida Ominus Rear Prop Guards are molded in RPM's trademark blend of engineering grade nylons for unmatched strength and durability. These Prop Guards are extremely tough and very light to minimize the effects of added weight on the airframe, weighing in at less than 5 grams per guard!
RPM Prop Guards for the Dromida Vista & Ominus are sold in pairs (one front set and one rear set will be needed for one Vista / Ominus airframe) and are molded in either dyeable white or black.
NOTE: Sold in pairs. One set of front and one set of rear Prop Guards are required for one Vista / Ominus. All four Prop Guards (2 – front & 2 – rear) must be installed at the same time. Failure to install Prop Guards in all four corners may cause adverse flying characteristics. RPM Prop Guards are designed as “bumpers” to help deflect light to medium impacts. They are not designed to save the Vista / Ominus from full speed or gravity fed crashes. A 0.05″ (or 1.25mm) hex key wrench is required (not included) for installation.
- Extreme strength and durability
- Weighs less than 5 grams per guard (including hardware)
- Sold in pairs (two pairs required per Alias)
- 0.05″ (or 1.25mm) hex key wrench is required (not included) for installation
This product was added to our catalog on June 21, 2016.