D815/D812 Basic Rear Joystick Toe Block Hinge Pin System (Basic Kit) by M2C Racing

M2C Racing
$1.99 Flat Rate Shipping!
Low Price: $50.99
This item is eligible for $1.99 flat rate shipping Learn More
Please be aware that pricing and product availability in-store may vary from what’s available online because each store is independently owned and operated. When you shop at HobbyTown you’re supporting your local community.

This is the optional M2C Racing Hot Bodies D812 Basic Rear "Joystick" Toe Block Hinge Pin System. This is the basic joystick kit that includes centerline bushings. These blocks are machined from 7075 Aircraft aluminum and the captured tapered hinge pins are made with 01 Tool steel for maximum strength. These pins are designed to rotate in the bushings and allow a freer motion of the suspension. With this design even if you bend a hinge pin, it will most likely bend in the smallest area of the pin. Because this area is not in the bushing or the arm, it will continue to move freely without binding the suspension. The bushings are made from delrin and will provide you with a much longer life than stock plastic bushings.

The BASIC KIT uses the stock settings of the vehicle and you will provide up to 2 degrees of toe and antisquat adjustment from the stock settings. The 4 and 5 dot inserts may also be used in the "C" block for fine adjustments to antisquat. This system is set up according to the set up sheet on page 30 of the manual. The diamond insert corresponds to the 1 dot insert from the D812 kit. The diamond insert in the B block corresponds to the 1 dot down insert from the D812 kit. The direction of the point indicates direction of offset of hole.

An optional insert kit is available (M2C4518) that will allow you to move the hinge pins in or out up or down up to 1 degree to shift roll center and increase vehicle width.


  • (1) M2C8961 front anti-dive block
  • (1) M2C8962 rear toe block
  • (3) M2C8901 tapered 4mm dia. hinge pins
  • (4) M2C4510 diamond inserts (hole in center of block)  
  • (4) M2C4511 2 dot inserts (hole 1 degree off center)  
  • (4) M2C4512 3 dot inserts (hole 2 degrees off center)
  • (4) M2C4513 4 dot inserts (hole 1/4 degrees off center)
  • (4) M2C4514 5 dot inserts (hole 1/2 degrees off center)
NOTE: the wider settings may not be roar legal.

This product was added to our catalog on July 4, 2013.