Aluminum L-Shaped Clamp Lock Servo Horn (Black) (24T-Hitec) by ProTek RC

ProTek RC
PTK-7816-BK
Read Reviews
5 (1)
Write a Review
Discontinued
This item is discontinued and no longer available for purchase. You may want to search our site for a similar item.

This is a ProTek R/C Aluminum L-Shaped Clamp Lock Servo Horn, and is intended for use with any servo that uses a 24 tooth spline output shaft. This extremely tough servo-horn has been machined from a solid block of aluminum for incredible precision, rigidity and durability. This horn features a clamp type design that grips the servo’s output shaft with enough force that even if the retainer screw comes loose, the horn will remain in place, increasing your chances of finishing the race! Additionally, the arm is 2mm thick, has 19.75mm & 24.25mm hole spacing and uses 3mm hardware to suit the geometry and hardware requirements of most vehicles.

Features:

  • Clamp design
  • 19.75mm & 24.25mm hole spacing (measured from output shaft screw hole, to linkage rod holes, center to center)
  • 2mm thick arm
  • 35.5x35.5mm Overall length
  • Linkage holes threaded for 3mm hardware
  • 24T Spline Output Shaft

This product was added to our catalog on August 14, 2014.

Nathan ter Stege
Verified Owner
Monday, Jul 4 2016 (5 months ago)
ProTek RC Aluminum L-Shaped Clamp Lock Servo Horn (Black) (24T-Hitec)
I ordered 4 of these at an incredible price and used them as cantilever shock mounts on my Axial wraith Spawn. Works a treat! It lowers the shocks mounting points for added ride height and allows the shocks to have more droop, i even added some shocks (without springs) on the opposite end of the L-shaped servo horns to add some dampening while the cantilever operates. Sweet setup no added body roll an lots of articulation!