30mm Lightweight 1/8 Droop Gauge Support Blocks (2) by Hudy

Hudy
HUD107704
$1.99 Flat Rate Shipping!
Low Price: $29.99
Add to Cart Add to Wish List
In Stock Online!
This item is eligible for $1.99 flat rate shipping Learn More

Store Availability Learn More

Frederick

Frederick, MD

Unavailable In Store

Check More Stores

This product was added to our catalog on December 21, 2009.

This is a set of two HUDY 30mm Lightweight 1/8 Droop Gauge Support Blocks. These Lightweight chassis droop gauge support blocks are a “must have” set-up tool for every off-road or truggy racer. The aluminum frame is CNC machined and drilled for super lightweight design and precise dimensions that guarantee accurate & precise down stop measurements.

Proper chassis droop is a critical, but often overlooked set-up adjustment of modern 1/8 scale off-road vehicles. Proper down travel balance from side to side is essential for proper handling, and because of this HUDY has developed and produced the first purposefully-designed droop guage support block set for 1/8 off-road.

Using the support blocks is simple. Remove the tires from the buggy and using a flat Set-up Board place the chassis on the support blocks; place the front support block below the servo saver, and place the rear support block below the rear bulkhead. Using the #107717 Chassis Ride Height & Droop Gauge, measure the droop under the wheel axle hex. Use the down stop screws to alter the suspension droop on each side of the car; the shocks should extend out far enough that they do not limit the suspension arm movement. Ensuring equal and proper suspension droop will allow the car to achieve a proper traction level and weight transfer depending on track conditions. Please refer to your vehicles set-up book to learn more about droop adjustment.

Features:
  • CNC-machined aluminum
  • Drilled for light weight
  • Exact size
  • Accurate & precise measurements
  • Highly recommended for all off-road buggy and truggy racers