2S 100C Hard Case Shorty LiPo Battery Pack (5mm) (7.4V/4250mAh) by ProTek RC Supreme Power w/5mm Connectors
This product was added to our catalog on February 24, 2015.
This ProTek R/C "Supreme Power" 100C Shorty LiPo Battery Pack is ROAR/EFRA/IFMAR approved and built using a hard plastic case that is required for use at sanctioned tracks and events. The battery features 2C charge rates and 5mm bullet connectors, with a set included, as well as an included 2mm connector. Plus, a set of 5mm to 4mm adapters are included so you can continue to use your 4mm charge leads to charge your battery!
This "shorty" style battery pack is perfect for any application that can benefit from the reduced weight of a smaller battery, and uses 5mm bullet connectors for an ultra low resistance connection. In fact the battery tubes can be accessed from either side of the case, allowing you to position the battery terminals in the direction that best suits your application!
This specially formulated battery features LiHV technology which allows the cells to safely reach a higher overall voltage (4.35V per cell vs standard 4.20V per cell). Achieving the higher voltage does require a LiHV capable charger, but the power gains are significant to the overall punch and power for the model. This battery can also charge and function perfectly at typical 2S voltages (8.4V), but please note: cell voltages exceeding 4.20V per cell is prohibited from sanctioned racing rules, such as ROAR, IFMAR, etc.
- Lightweight Shorty Pack
- 100C Discharge Rate
- 2C Charge Rates
- Hi-Voltage LiHV Capable
- Durable 5mm Bullets
- ROAR Approved
|Battery Model||Supreme Power 100C
|Number of Cells||2 Cell
|Dimensions (WxLxH)|| 46.5x96.5x25.1mm
|Maximum Charge Rate||2C (8.5A)
|Continuous Discharge||100C (420A)|
LITHIUM POLYMER SAFETY INFORMATION
1) DO NOT leave the battery in your model when charging
2) DO NOT leave unattended when charging
3) ALWAYS balance charge the battery
4) ALWAYS use a LiPo charging bag
5) YOU MUST use a Li-Poly specific charger to charge the pack (NiMH or NiCD only chargers WILL NOT WORK!)
6) YOU MUST not over discharge the Li-Poly battery pack
7) READ & UNDERSTAND the instructions carefully before operating this battery
NOTE: When using high energy Li-Polymer Batteries, please do not over-discharge or over-charge batteries as this will result in over heated batteries. Discharging capacity can't exceed 80% of the max capacity of the pack after full charging to ensure a good cycle performance. It is recommended to fully charge a brand new battery before using and only discharge the battery 50% for first 5 cycles. Always monitor race time and/or set a low voltage warning on ESC (End voltage cannot be lower than 3.2v per cell). Do not use a battery that has too low a voltage.
Do not expose batteries to sunshine or store/charge batteries at the temperature above 35°C or in a closed car. The high temperature environment could cause damage to the pack or make it burst. If the battery becomes hot while fast charging, high current discharging or racing, do not charge the battery until it has cooled completely. Wait about 20 mins, then inspect prior to recharging.