2206-20 Brushless Motor (280W, 2100kV) by Cobra
This product was added to our catalog on February 26, 2016.
The Cobra CM 2206 2100kv is a design that has been proven in the FPV racing community to be an ultimate contender in performance and power output for 220-260mm FPV Racing Drones when combine with 4s LiPo power. Optimized for 6" props, each motor can produce over 1100 grams of thrust (depending on ESC, and prop choice), this motor is no slouch.
The Cobra CM-2206 series motors feature a 3.0mm motor shaft for extra strength, as well as oversize ball bearings to support the shaft and provide a long life. The stators are made with 0.20mm laminations for maximum efficiency and minimum Eddy Current losses. Since these motors are typically soldered directly to the speed controller to save weight, the 2206 motors come without bullet connectors and feature extended pre-tinned motor leads that are 10 inches (254mm) long. These motors also have 3mm threaded holes in a 16x19mm pattern on the back plate for easy installation on your model.
Cobra Brushless Multirotor Motors offer performance and value for your RC Models. They are built from high quality components, and are designed to give years of top-level performance. All Cobra Motors are shipped in a custom designed package that features protective foam on all sides, with separate compartments to protect the motor and accessory pack.
Cobra CM-1806/30 Motor Specifications:
Stator Diameter: 22.0 mm
Stator Thickness: 6.0 mm
Stator Slots: 12
Pole Count: 14
Motor Wind: 20 Turn Delta
Motor Kv Value: 2100 RPM per Volt
Motor Weight: 36.5 grams (1.29 oz.)
Outside Diameter: 27.0 mm (0.9 in.)
Motor Shaft Diameter: 3.0 mm (0.079 in.)
Prop Shaft Diameter: 5.00 mm (0.197 in.)
Motor Body Length: 16.5mm (0.650 in.)
Overall Shaft Length: 35.3mm (1.390 in.)
Motor Timing: 5-10 degrees
PWM Frequency: 8 KHz
- (4) M3x5mm Motor Mount Screws
- (4) M3 Flat Washers
- Machined Aluminum Prop Washer
- Locking Prop Nut with Nylon Insert