Navigation

  • O. S. Engines .46AXII ABL 40G E-3071 Muffler

    Product Number OSMG0548
    $0.00

    y Please allow 5-7 days for free in store pick up or flat rate shipping.
    1/10 Desert Truck Rtr
    qty $0.00

    This is the O.S. Max .46AXII ABL BB Model Airplane Engine with Muffler. Ideally suited to sport and aerobatic aircraft. Distance from remote needle to end of cr...*More

    This is the O.S. Max .46AXII ABL BB Model Airplane Engine with Muffler. Ideally suited to sport and aerobatic aircraft. Distance from remote needle to end of crankshaft: 4.7 (119.4mm) Distance from center of engine to drive hub: 2.4 (61mm) Distance from center of engine to end of crankshaft: 3.4 (87.6mm) Distance/crankshaft center to muffler exhaust outlet: 3.9 (100.5mm) Height from crankcase bottom to top of cylinder head: 3.3 (85.2mm) Height/crankshaft center to top of cylinder head: 2.6 (67.4mm) Width including mounting tabs: 2 (50.8mm) Width not including mounting tabs: 1.4 (35.6mm) Width/mounting hole centers same side: .69 (17.5mm) Width/mounting hole centers opposite side: 1.7 (44mm) Diameter of muffler body: 1.5 (38.1mm) Angle of muffler in relation to engine: 4¦ Carburetor Settings; Needle Valve: 1+ to 2 turns out from closed position Low Speed Needle (aka: Mixture Control Valve): Close throttle rotor gradually from the fully opened position until it is just fully closed (do not turn further). Screw in the Mixture Control Screw until it stops. Now open the Mixture Control Screw approx. one turn. jxs 03/06/12 ir/jxs*Less

    Rating:
    Print This Page
    • Advanced Bi-Metallic Liner.
    • Also, the plating process is more consistent, resulting in a more precise fit between piston and sleeve for better compression, longer life.
    • Ball bearing-supported crankshaft
    • Side exhaust E-3071 Power Box muffler with squared-off shape enables it to fit into a variety of cowls 40K carburetor with rear angled needle valve for added safety
    • This helps the metalto bond to the cylinder and is more durable.
    • This process uses a double layer ofplating material rather than one thick layer.
    • Bore:0.866 (22mm)
    • Crankshaft Size:1/4-28
    • Displacement:0.455 cu in (7.45cc)
    • Power Output:1.65PS, 1.67HP/16000 RPM
    • Practical RPM:2000-17000
    • Recommended Propellers:10.5x6, 11x6-8, 12x6-7, use 10x6 for break-in
    • Stroke:0.772 (19.6mm)
    • Weight:13.3oz (378g) without muffler
  • To browse selection and pricing, enter your Zip Code below then click SHOP THIS HOBBYTOWN.
    X
    HobbyTown locations within miles of