Navigation

  • O. S. Engines 160Fx Ring 60F Carburetor E5010 Muffler

    Product Number OSMG0660
    $0.00

    y Please allow 5-7 days for free in store pick up or flat rate shipping.
    1/10 Desert Truck Rtr
    qty $0.00

    This is the O.S. Max 1.60 FX High-Performance R/C Engine used for Sport and Aerobatic Aircraft. This 1.60 FX is Designed to use a Muffler or Tuned Pipe. Needle ...*More

    This is the O.S. Max 1.60 FX High-Performance R/C Engine used for Sport and Aerobatic Aircraft. This 1.60 FX is Designed to use a Muffler or Tuned Pipe. Needle Settings: High Speed: 2 - 2.5 turns out from fully closed Low Speed: .75 turns out from fully closed with the throttle fully closed COMMENTS: Recommended is a 450-550cc fuel tank which allows approximately 10 to 12 minute flights. Locate the fuel tank so that the top of the tank is 5-10mm (1/4-3/8) above the level of the needle valve. A 1/16 wire (not included) can be used to extend the needle valve by inserting the wire into the pre-drilled hole on the end of needle valve and tightening it in place with the supplied set screw. Remote needle valve is held in place by a nut instead of screws. To use a Tru Turn spinner and an APC propeller, modeler will need the Tru Turn jam nut set TT-0378-A (not carried at this time). MAF 5/23/00 ir/jl updt lmm 3/31/09*Less

    Rating:
    Print This Page
    • Engineered for low fuel consumption and tight installations.Side exhaust with muffler with rotatable exhaust outlet.
    • Extra long crankshaft & jam nut w/prop washer to secure the propeller #60F Carburetor with remote needle mounted on the backplate of the engine (to keep fingers away from the spinning propeller).
    • One-piece crankcase
    • Schnuerle porting (Schnuerle scavenging)
    • Steel liner and ring with Aluminum piston
    • Tall, squared heat sink head for added cooling
    • The remote needle valve can be mounted three ways: vertical, horizontal, and separate from the engine.
    • Twin ball bearing-supported crankshaft
    • Wide wing- shaped exhaust port contributes to higher torque at lower rpm.
    • Bore:33.6mm (1.32)
    • Crankshaft Thread Size:3/8-24
    • Crankshaft Threaded Area:28mm
    • Displacement:26.23cc (1.60 cu in)
    • Exhaust mounting screws width (center to center):42mm (1.65)
    • Height:123.2mm
    • Horsepower:3.7 PS, 3.65 HP at 9, 000 RPM
    • Length:115.5mm (distance from the backplate screw to drive washer)
    • Muffler:275g (9.7oz)
    • RPM range:1, 800 - 10, 000 RPM
    • Sport:17x10-13, 18x10-12
    • Stroke:29.6mm (1.17)
    • Suggested Props:15x12-14, 16x10-14, 16.5x10-13
    • Weight:Engine- 1235g (43.6oz) with muffler
    • Width:51.5mm (width of engine neglecting engine mounting flanges)
    • ~Coming Soon
  • To browse selection and pricing, enter your Zip Code below then click SHOP THIS HOBBYTOWN.
    X
    HobbyTown locations within miles of