This is a Kwik Ramp Portable Jump for Radio Controlled Vehicles. COMMENTS: How to setup instructions: 1. Use CA or epoxy glue to attach the four plastic tubes o...
More
This is a Kwik Ramp Portable Jump for Radio Controlled Vehicles. COMMENTS: How to setup instructions: 1. Use CA or epoxy glue to attach the four plastic tubes onto the height adjustment wires. 2. Press the wire ends into the edge of the ramp sides at any point along the length of the sides. Do not glue wire ends to ramp. 3. Position wires straight across from each other for the lowest ramp height. To increase the height, move one end of each wire (on the same side of the ramp) closer to the middle in even amounts. JAL 7/3/00 ir/jl
Less