Navigation

  • E-Flite 60-Amp Pro Switch-Mode BEC Brushless ESC V2

    By E-Flite |
    Product Number EFLA1060B
    $0.00

    y Please allow 5-7 days for free in store pick up or flat rate shipping.
    1/10 Desert Truck Rtr
    qty $0.00

    The E-flite 60-Amp Pro Switch-Mode BEC Brushless ESC (V2). This is a high-quality sensorless brushless electronic speed control with an integrated switch-mode ...*More

    The E-flite 60-Amp Pro Switch-Mode BEC Brushless ESC (V2). This is a high-quality sensorless brushless electronic speed control with an integrated switch-mode BEC that is very lightweight and efficient. It can operate without the need for a separate receiver battery to power your servos and receivers, saving you weight and complication.*Less

    Rating:
    Print This Page
    • 3- to 6-cell Li-Po, 9- to 18-cell Ni-MH/Ni-Cd input voltage
    • 5A continuous current, 5V switch-mode BEC circuit (proper cooling and airflow required)
    • Auto motor shut down if signal is lost or there is interference
    • Drive up to 7 analog or 6 digital standard-sized servos with the BEC on any recommended input voltage
    • Finned heat sinks
    • Pre-wired connectors E-flite EC3 connector on battery input and 3.5mm gold bullet connectors on motor output leads
    • Programmable low voltage cutoff with settings for 3-cell Li-Po (9V), 4-cell Li-Po (12V), 5-cell Li-Po (15V), 6-cell Li-Po (18V) or 74% of battery starting voltage
    • Programmable motor braking
    • Programmable soft start for helis and airplanes
    • Programmable throttle input range (1.1ms 1.9ms or 1.2ms 1.8ms)
    • Programmable timing 5 user-selectable ranges for use with a large variety of brushless motors
    • Radio system power on/off switch
    • Safe power-arm mode prevents accidental starts
    • Stronger BEC for support of most 3-axis stabilization systems
    • Up to 60 amps continuous current with proper air flow and 75 amps burst current (15 seconds)
    • Utilizes new smaller MOSFET technology to minimize weight
    • Cells w/BEC3 6S Li-Po or 9 18 Ni-MH/Ni-Cd
    • Continuous Maximum Current60A
    • Height0.61 in (15.5mm)
    • Input Connector Types13 AWG with E-flite EC3 connector
    • Length2.85 in (73.0mm)
    • Momentary Peak Current15 sec @ 75A with proper cooling air flow
    • Output Connector Types13 AWG with 3.5mm gold bullet connectors
    • Weight2.65 oz (75.0 g)
    • Width1.30 in (33.0mm)
  • To browse selection and pricing, enter your Zip Code below then click SHOP THIS HOBBYTOWN.
    X
    HobbyTown locations within miles of