This is your no-solder LED lighting solution for RPM Light Canisters RPM Tail Lights! Use RCL106A to add 6 3mm white LED lights to RPM Roof Canisters to any...
More
This is your no-solder LED lighting solution for RPM Light Canisters RPM Tail Lights! Use RCL106A to add 6 3mm white LED lights to RPM Roof Canisters to any controller with 6 extra constant LED channels (see RCL104). Add-On for RCL104 to make a 10 LED System.Compatible with RPM Roof-Mounted Light Bar Set RPM80922, RPM80923 RPM80925 --Direct fit for Slash 4x4, Slash SC10. To change LED sizes or colors use 5mm or 3mm LEDs. This system add-on requires a LED controller and power source. Add-On for RCL104. If not used with RCL104 use with Standard 10 LED Controller RCL5051 or any other LED controller with available channels.Includes:Instruction Set - (6) 14" wire extensions RCL539014(6) 3mm white LEDs RCL5280W (6) 2P connector housings (2) zip ties RCL5080Specs:TOTAL LED CURRENT DRAW (@6V): 110mA (A standard servo draws approx. 350mA) Blue, Green, White, White Strobe, Red Strobe LEDs FORWARD VOLTAGE: 3.2V MAX CURRENT: 30mA Amber, Red LEDs FORWARD VOLTAGE: 1.9V MAX CURRENT: 30mA DIY HOBBYISTS: If connecting LEDs directly to power a current limiting resistor must be installed on each LED or it will blow and void the warranty. (160 ohm @ 6V)*Lights are designed to be used in extreme nighttime and low visibility running environments and are very high output. *DO NOT look directly into beam.
Less