The RPM True-Track Rear A-arm Conversion kit eliminates one of the biggest headaches associated with the incredibly popular Maxx line of trucks. Rear toe angles are nearly impossible to set accurately and there isn t a gauge currently made that can tell the T-Maxx / E-Maxx owner if each individual wheel s toe angle is set correctly in relation to the chassis. Our rear end kit completely eliminates the rear toe link, locking in the rear toe angle at a solid negative 1.5 degrees per side for a total rear toe of negative 3 degrees (of Toe-In), effectively eliminating rear bump steer! Our design retains the stock upper pivot ball in the RPM axle carrier to allow precise camber adjustments while the lower pivot ball has been eliminated in favor of a rock-solid, beefy 4mm diameter hinge pin that locks-in the rear toe angles for race winning consistency. All aspects of the RPM rear end conversion have been beefed up for rugged durability and slop free movement throughout its range of travel. We ve completely redesigned the rear end yet all stock suspension geometry has been retained. Additionally, we ve incorporated our oversized bearings (3mm larger in diameter than stock) into the design, providing 2mm more bearing contact with the axle while doubling the bearing load rating tripling the fatigue rating over stock bearings.
Sport Maxx 4WD Upgrade Modules
The forward only conversion kit makes Revo legal for racing where reverse is not allowed. It reduces the internal rotating mass in the transmission for quicker acceleration and provides a small, additional weight reduction by eliminating the OptiDrive module, and the micro servo and linkage. When the transmission is fitted with the forward only conversion kit, the weight of the transmission is reduced by either 61 grams (when using the aluminum output shaft) or 48 grams (when using the optional steel output shaft).